Inertia Dynamometer Chassis with standard wheel base up to 84 inches
Measures up to 750 horsepower, 200 MPH
Dynoware EX+ hardware includes:
: CPU Module: Com Port Interface, runs on 12VDC & 110VAC
: Dyno Module: Sends and receives data to and from the Dyno
: Atmosperic Sensing Module: Automatically measures absolute pressure, air temperature and relative humidity
: RPM Module: Receives and processes ignition (spark) signals for correct engine speed measurement
Control Panel with Arm
Primary Wire Inductive tachometer pickup
Secondary Inductive Pickups (spark plug clamps connect directly to spark plug wires)
WinPEP 7 Software, Windows XP
Bike Starter System (requires battery)
Wheel Lock

Windows Media Player     QuickTime Player

Windows Media Player      QuickTime Player

Windows Media Player      QuickTime Player

Need QuickTime Player? Click Here!

AIR / FUEL RATIO

Tuning with a Dynojet dyno has never been easier! With the addition of our new air/fuel ratio monitor, every dyno run can show you not only horsepower and torque, but also exact air/fuel ratio. This takes the guesswork out of fueling adjustments. The air/fuel ratio graph shows a rich/lean condition at each RPM during the dyno run.

The air/fuel ratio monitor also includes a high temperature sample line with a dual pump assembly and moister separator.

Wide-Band O2 sensor has a range of 10.29:1 to 23.0:1. Specialized 6 wire heated and referenced sensor is self-calibrating for long, consistent life.